step1: place a cube. step2: then add segments. step3: use right click extrude not extrude tool. step4: then select polygons used to make index finger. step5: right click and choose clone (be sure to click apply). Step6: then slide clone over to middle finger. step7: delete polygon where finger will connect to palm. step 8: right click bridge. step 9: use select tool on points (click and drag from first point to second, release, then click and drag third point to fourth, continue this until finger and hand are connected.) Repeat steps4 through 9 until hand is complete. Step 10: fine tune look of hand.
No comments:
Post a Comment