hand

Hand

step1: place a cube. step2: then add segments. step3: use right click extrude not extrude tool. step4: then select polygons used to make index finger. step5: right click and choose clone (be sure to click apply). Step6: then slide clone over to middle finger. step7: delete polygon where finger will connect to palm. step 8: right click bridge. step 9: use select tool on points (click and drag from first point to second, release, then click and drag third point to fourth, continue this until finger and hand are connected.) Repeat steps4 through 9 until hand is complete. Step 10: fine tune look of hand.

Animated Living room

Animated Living Room

I believe I have everything the teacher wanted in it even if it isn't quite in frame.

Lights

Noise Illumination

Noise Visibility

Omni Rotating Colors

Spot Round

Spot Round Merged

Volumetric Spot

deformers

Twist
Set segments, place the twist deformer inside the object you wish to deform then grab the little orange handle and twist away.

Explosion
Set segments, place the deformer as a child of the object you wish to go boom grab the little orange knob and pull.

Bend
Set segments, make the bend deformer a child of the object you wish to bend, grab orange handle and have fun.

Explosion fx
Set segments, place the explosion fx deformer as a child of what you want to deform pull orange handle and have fun.

Squash and Stretch
Squash and stretch is slightly different. first set how many segments you want, then place the deformer in the object, select the deformer go down to the object tab in the attributes panel and use the factor and expand sliders to make your alterations.

Shatter
Set how many segments you want, place your deformer as a child of your object, grab the handle and pull.

Bulge
Set segments, place bulge as child of object, grab handle and go.

Midterm Project Living Room

This was a really fun project and the only issue I had was that I had missed the day that we learned how to do the window cut outs so when it came time to actually cut out the walls I didn't know how. Other than that it was fun learning to make tables, table cloths, a flower, vase, and a working lamp. The moulding was a bit difficult but once you know how to do it it was quite simple.